SKF 2208 E-2RS1TN9/C3 Self-Aligning Ball Bearing - 40 mm ID, 80 mm OD, 23 mm Width, Cylindrical Bore, C3 Stainless Steel The use of a sliding

The use of a sliding hammer is particularly recommended when there is no support surface available or when this is too sensitive

2 Outer Chest Pockets

220 – 240 V / 50 – 60 Hz / 2

The bell-shaped ball joint puller of series 128 is used for pressing out the ball studs when disassembling ball joints and tie rod ends on tie rods for all vehicle types

SKF 2208 E-2RS1TN9/C3 Self-Aligning Ball Bearing - 40 mm ID, 80 mm OD, 23 mm Width, Cylindrical Bore, C3 Stainless Steel The use of a slidingSelf Aligning Ball Bearing sealed design and lightweight cage Self Aligning Ball Bearings have two rows of balls and a common concave sphered raceway in the outer ring. They are insensitive to angular misalignment of the shaft relative to the housing. The sealed design provides protection against contamination. Manufactured to precision tolerance class for demanding applications. Features a lightweight polyamide cage for reduced noise and friction.